Youâ€™re driving down the street, happily obeying the laws and enjoying the ride when suddenly you notice clouds of what appears to be smoke, emerging out from under your hood. You may also notice some hesitation from your engine or lag time when you push your foot down on the gas pedal. Checking your dashboard panel, you will most likely see the engine light on or the temperature gauge in the red zone.
First things first: Donâ€™t panic.
Those white billowy clouds are not smoke, but steam rising off your engine because your car has probably overheated. Engine overheating happens for a variety of reasons Autel Maxisys MS908CV, but the most common is when your vehicle doesnâ€™t have enough engine coolant to prevent the engine from getting too hot. This happens when weâ€™re driving in heavy stop-and-go traffic, when we forget to check vehicle fluids, or both.
When you find yourself in this precarious situation follow these steps to get back on your way:
1. If the air conditioning is on, turn it off and roll down the windows. You can also try turning the car heater on at full speed, which will dissipate some of the heat off the engine and may help prevent complete overheating.
2. Without delay pull the car out of traffic and on to the side of the road or into a parking lot.
3. You need to turn off your car and pop the hood release. If the hood feels very hot to the touch or if you see steam coming from under the hood, wait until the hood cools and then open it all the way.
4. DO NOT open the radiator cap or touch the engine until the engine has cooled completely. This may take as long as 45 minutes to an hour. The radiator is under pressure, so it could cause you serious harm if you open the cap while itâ€™s hot.
5. When the engine has cooled down completely and you can touch it comfortably, check the coolant reservoir tank it looks like a plastic milk jug with a hose going to the radiator. Carefully open the radiator cap, paying particular attention to the radiator and coolant level. If it doesnâ€™t have any coolant, youâ€™ll have to add coolant, water or both if you have them, directly into the radiator. Be certain to fill the radiator to the top and if you have both coolant and water, use a 50/50 mix.
6. Replace the radiator cap and check all hoses, making certain they havenâ€™t sprung a leak or busted.
7. Restart the car and check the temperature gauges on the dash. If the needle starts moving into the red zone, shut off the engine immediately, wait a few minutes and try again.
Remember that it is possible to continue driving while your car is hot, this is most important if youâ€™re alone on a dark road or in unknown surroundings. In this case, start up the engine and continue driving until the gauge reaches the hot zone, then stop, turn off the engine, let it cool down considerably and continue again, repeating the stop-and-start process until you reach a safe destination. Please do not attempt to drive in this manner over long distances; only use this method until you find a well lit and safe area to examine things further Autel MaxiTPMS PAD. Or better yet, until you find a reliable repair shop.
It is important to understand that engine overheating can be caused by a variety of problems; a blocked radiator, a fan that stops working, a bad water pump or a stuck thermostat, so if the coolant level is at normal levels and you are overheating see Mr. Transmission right away!
Our greatest fear when getting behind the wheel of our automobiles is that we end up in a car accident. While we wouldn't like not to think about it, there are millions of accidents every year and tens of thousands of people die each year in car accidents. Fact is that you need to be prepared just in case you yourself are involved in one. If you are unfortunate enough to be involved in an accident please remember these few helpful hints to try make the process a little bit easier.
Emergency Kit-This is actually something you to take care of before you ever even get into your car and should have there regardless of an accident. Inside your glove compartment you should keep kit containing a cell phone, pen, paper, flashlight and a disposable camera. You should also have a list of all emergency contacts and medical allergies. I would highly recommend laminating the list so that it does not get ruined in case fluids come in contact with it Topdon ArtiMini. In your trunk, you should keep another flashlight, emergency flares and either a set of emergency cones or warning triangles.
Safety-You always have to remember to keep safety first Autel MaxiTPMS PAD. If it is a minor accident, both drivers should move their vehicles to the side of the road and out of the way of approaching traffic. If it is a more serious situation and someone is injured and the cars cannot be moved, everyone should remain in their cars until help arrives. If you are able to get to your cell phone, call for help.
Information Exchange-You should exchange the following information with the other individual in the accident: name, phone number, address, insurance company, policy number, license plate and driver's license number. Compare the name on the driver's license to the insurance policy and ensure that it is the same. If it is not, establish the relationship of the driver to the policyholder. You're also going to want to get a complete description of the car and exactly where the accident took place.
Photograph the Scene-Take out the camera from your kit and photograph the car and all surrounding areas. You're going to want to fully document everything in the area including any witnesses and their contact information.
Accident Report-On the rare occasion that the authorities do not show up, make sure you immediately file an accident report at the police station and with your insurance company. This can sometimes be done via the Internet.
Something else that is going to help here is going to be a complete knowledge of your own insurance policy. This can help you in the scene when deciding how to possibly move your vehicle or for emergency services. For instance, towing services and rentals may have already been included in your policy. If that is the case, why risk further damage or drive what could be an unsafe vehicle when you can have it towed and rent a safe vehicle at no additional charges.
Accidents are horrible things, and we obviously hope that you never have to experience one. However, if it should happen, remain calm and follow these steps in that should make the process a little bit easier.
It might be often daunting to negotiate with a Sacramento auto dealer and gather as much of information as you can about a second hand car. However, things will get easier if you do some homework. Make your way through the used car buying process by placing the right queries while talking to the Sacramento used car dealers. As a result, you will be able to find the information you need for making a wise decision. Discussed below are a few basic queries which cover different aspects of purchasing a pre-owned car.
If you already know about the cars sales value, then get the following queries answered by the Sacramento used car dealers and come up with a right decision.
Is it a certified used car in Sacramento, May I see the documents of pre-certification checking?
Each certified pre-owned car has to go through a mechanical inspection just before it gets certified. Ask the Sacramento used car dealers to produce documents to show you what was repaired. It is an easier way to avoid any kind of future problem.
Where the car was purchased from?
If the car was a trade-in to the Sacramento auto dealership, ask it to present you its maintenance records. Be flexible and give it the option to hide both the car owners name and contact details. If the car was purchased at an auction, make sure it is thoroughly inspected by an expert mechanic in Sacramento.
Who has certified your used car in Sacramento?
Remember Autel MaxiDiag MD808, what matters in the purchase of a second hand car process is its certification by the original manufacturer rather than any insurance supported program.
How long can I test drive the used car?
The Sacramento used car dealers business is slow now. Try to make the most of it. Ask if the car dealer will allow you for overnight test drives or not. Also, give in writing that you wont drive it over 100 miles, confirm about your insurance, and youll drive it back with a full oil tank (if you leave it with a tank full of oil).
Can you have access to CarFax report before car purchase?
All the reputed Sacramento used car dealers will have no objection to this. An unreliable dealership may oppose or can even present an altered report. Make sure you have the original CarFax report where the car identification number is same as the VIN on the used car you are intending to purchase.
What is the Sacramento dealers return policy?
Probably, professional dealers wont think it as an absurd question. They are customer-friendly and would like to give you some time to rethink the car purchase and are dedicated to ensure you the best value. No used car dealer in Sacramento will give you cash back.
What is the offered price for the used car in Sacramento?
The used car deal must be profitable for both the customer and dealership. Dealers are interested to make profits through financing, but in Sacramento market, total cash payments should bring you at least some discounts. Negotiate to cut 5% off the listed used car price topdon elite. Make it clear to the auto dealer it removes a lot of hassle when deliver them full amount in cash.
Rick Pruett worked with well known Sacramento used car dealers (), hence he knows what are the things you should consider while looking for an economic car deal in the market. His checklists have helped many to find the most suitable deal on used car Sacramento within no time.
Different car audio enthusiasts have different tastes when it comes to designing their car audio system but a common desire to all the music junkies is to have a loud stereo system. To create a customized car audio system that produces high-decibel-level sound professional help can be sought or you can do it yourself and save the cost of the labor autel maxisys ms906. Here is a simple method as how to build a car stereo.
Here is the list of the things that you will need to turn your average car audio system into an elite audio system: Car amplifier, Multiple channel speakers, Sub woofer, Equalizer, Stereo deck, Wiring harness adaptor, Amplifier wiring kit, Patch cables. These are very few things that would help the user to build a new loud car stereo with ease.
In most of the factory installed speakers the output of the unit will be divided among the speakers. For example if the output of the stereo unit is 200 watts then this output will be shared among the door speakers, the woofer and the sub-woofer. Hence by choosing an after -market speakers with multiple channels full power will be devoted to all the speakers.Before replacing them by yourself refer the car owner`s manual for specific instructions.
Replace the door speakers with multiple channel speakers. These kinds of speakers provide distinct interpretation of the sound throughout the sonic spectrum. Speakers coupled with a tweeter, a mid range and a woofer can produce sounds of high quality. It is to be noted that if different levels of sound comes out of a single speaker then it creates a `messy` or a distorted sound.
Adding an amplifier to the speaker system increases the output tremendously. The amplifier will take the power provided by the stereo and will boost its signal to the speakers. The size of the amplifier should be properly matched to the stereo and the speaker`s capacity.
More than one amplifier can also be used but using it is usually reserved for competition systems.
Adding a subwoofer to your music system is the best way to interpret to interpret low tones and bases. Usually the subwoofers are mounted in the rear end of the vehicle; specifically in the trunk. If you prefer to mount them beneath a seat or behind the seating of a pick-up truck then low profile sub woofers will be best suited. Powered subwoofers are perfect for those without amplifiers as a part of their stereo system.
The final step in increasing the decibel level of your audio system is rewiring the speakers with high quality wires. These wires can increase the quality of the sound generated. The main function of the speaker wire is to deliver the stereo signal from the amplifier to the speakers Autel MaxiCOM MK808.
But using a high quality speaker wire can decrease the energy lost during this transmission. Most of the high quality speakers will be coated with precious or semi-precious metal to maximize the conductivity of the wires and thereby increase the transmission. In this way, how to build a car stereo becomes a simple question.
The use of ethanol as an alternative fuel is becoming increasingly popular by ever conscious consumers wishing to do their little bit for the planet. It may even be a better alternative to bio fuel, it seems that it is a lot more pleasant to make at any rate.
What is Ethanol?
Ethanol is a grain alcohol, or plant mass formula derived from the natural sugars found in bio mass, or vegetation such as corn, wheat, barley, potatoes and sugar cane. This is then processed to make a renewable form of fuel or fuel additive, which is both cost effective and good for the planet. Many cars are able to run on Ethanol and gasoline mixtures. Although at the moment, the mixtures are only a ratio of 10% Ethanol, to 90% fossil fuel.
Benefits of Ethanol
There are many benefits of using an alternative fuel such as Ethanol, for starters it is a renewable resource Autel MaxiDiag MD808, fossil fuels used to make gasoline is not renewable, so one day they will run out, it is because of this that people, have become more aware of alternative fuels and additives. Another good reason for using an alternative fuel such as Ethanol is the reduction of pollution Autel MaxiSys MS906TS, we only have one planet and if we keep polluting it we may very well find ourselves with nowhere to live. Any steps that we can make toward reducing pollution is a positive. Another good reason to consider a fuel alternative such as Ethanol is that it is far more cheaper to use and make, the main cost involved in making Ethanol is in the processing method.
How is Ethanol Produced?
The process used consists of 8 stages, corn is the main product used in this method, Milling the corn, to make it into a fine powder, or meal Liquification, which is mixing the meal with water and Alpha-amylase, then heating it at temperatures of 120-150 deg Celcius, the heat reduces bacteria. Saccharification, is the process of cooling the mash, and adding glucoamylase, this converts the starch to dextrose, Fermentation, is where the yeast is added to ferment the sugars to convert it to Ethanol. This process consists of the mash going through several different tanks, and takes about 48 hours.
Please note that this procedure is risky and I do not recommend making biodiesel without further research of the process, these are just general guidelines of the making process, if you wish to actually make your own bio diesel please consult expert companies or professionals.
Distillation, the mash now contains about 10% alcohol and 90% non fermentable solids, the solids are now separated from the alcohol, to reach about a 96% strength of alcohol.
Dehydration, is where the last of the water is removed to make the alcohol about 200 proof.
Denaturing, is used then to make the alcohol unfit for human consumption, this is done by adding a small amount of gasoline, like 2-5%.
There are 2 co products derived from this process as well. The first is the non fermentable product, this is used as a livestock feed, the second is the carbon dioxide which is collected from the process and sold to other industries.
There are many reasons to use Ethanol as either an additive or an alternative fuel; one of the main reasons is the reduction of pollution. Regular fossil based fuels are not only damaging to the environment they are a non-renewable resources; once they are gone they can never be replaced, or regenerated.